PRO-HEAT TITANIUM IC HEATER 
UNBREAKABLE!!! 
PRICING
 


  50,75,100 watts ......................$40.00

 150,100,250 watts ...................$45.00

300,350 watts ..........................$50.00

  500 watts...............................$95.00
  • Controlled by micro computer with high precision of ±1°F Titanium Heating Tube
  • Automatic protection device activates when sensor wiring is disconnected or shorted. 
  • Double Heating Tube 
  • Very Durable and Reliable 
  • Safe & easy to operate. 
  • Aquarium IC thermostat uses IC to control the heater to adjust desired aquarium temperature. 
  • Operating temperature range: 60° F to 93° F 
  • Ideal for saltwater & freshwater

    • ***Chemical resistance of titanium is very good service ( no effect-excellent) against sodium chloride (NaCl)-SALTWATER
    ***IC means integrated circuit 
KEY FEATURES
  1. Temperature indicator 
  2. Temperature control dial 
  3. plug 
  4. ON / OFF indicator 
  5. Main IC unit 
  6. Cord 
  7. Rubber cap 
  8. Titanium Heater tube (Built-in Sensor) 
  9. Suction cup 
INSTALLATION
 
 
  1. Place the heater tube unit in a vertical / horizontal position in the water, then press the two suction cups against the glass firmly to adhere to the aquarium. For best results, position the heater fairly deep where the water can be circulated strongly and freely . 
  2. Set the desired temperature by turning the temperature control dial. Then wait a few minutes until the heater tube is acclimatized to the aquarium water temperature. 
  3. Plug the power cord of the heater to the receptacle pilot light will be ON or OFF. ON indicates the heater is working to maintain setting temperature. OFF indicated the heater is not working because setting temperature is reached. 
  4. Few hours later, check the water temperature with an accurate thermometer. If needed, compensated the temperature by turning the temperature control dial as required.
Back to Pricelis